Introduction
Operational Modes
The following operational modes shall be supported by the B2B system.
| Mode |
Description |
Source |
Target |
RF sync ext |
RF sync inj |
| KSE |
Evt-Kick-Start |
Ring |
N/A |
N |
N/A |
| B2E |
Bunch-2-Extration |
Ring |
(fixed) target, dump... |
Y |
N |
Functional Requirements
The main functional requirements are defined in the
technical concept as follows.
- all B2B and bunch to fixed target transfer at FAIR shall be supported
- both synchronization methods are available: Phase Shift and Frequency Beating
- the B2B transfer should be fulfilled within 10 ms and the precision better than 1 degree of the phase difference between bunch to bucket center
- the GMT shall be capable of providing timing messages for diagnostics and instrumentation
- the 1st one can be used for trigger generation in coincidence upon transfer/extraction
- the 2nd one is a follow-up message used to distribute diagnostic information on the transfer
- the B2B system has a close link to the MPS
- the provides signals to inhibit extraction or triggers emergency extraction
- the B2B system generates a trigger signal for kickers
- a so-called Trigger Decision Module might serve as an interface between the B2B and the MPS system
--
DietrichBeck - 22 Nov 2020