Hochstrom Netzgerät Networkinterface Die Netzzgeräte werden von eim C Programm angesteuert. Dieses verwendet libfesl um die Register im Accu anzusprechen und dad...
Highcurrent PowerConverter Networkinterface The power converters are driven by a C program. This used libfesl to address register in the Accu thereby drive the d...
Starting power converter software on LynxOS sytem The power converter control program was originally operated on a LynxOS system using a pci card that would send ...
Testing Environment for the power converter control program Using the test rack Testing the program with a real power converter could be a bit troublesome. There...
Overview: All the following scripts are located in /usr/local/bin/ and can be run just as command mole@scuxl0xyz $ script.sh Scripts with Load parameters * P...
Power converter control software The magnet power converters at the test station are controlled by a software package, which enables the user to steer it by: *...
Load parameters used for the power converter SIS100 dipole Main parameters The load maximum current was currently set to FMT_LOAD_MAXIMUM_CURRENT='17e3' The po...
Using the general input output of the SCU for TTL triggers Introduction The SCU provides 2 groups of lemo inputs. At the stage of this writing only two of them a...
SCU's for the power converters used at the magnet test stations The SCU's at the test station are SCU's as they will be used in the FAIR machine. These boot from ...