Epics@GSI Webhome

HadCon Multipurpose Controls Protocol Cmnd DAC

Introduction

Command description of the API command DAC for HadCon2.

With the help of the DAC command, we could access directly the DAC peripheria output. The Channel are following the connector pin numeration from pin 0 to pin 7 are the DAC channel output, pin 9, 10 are ground.

Main

DAC cmnd

1. DAC : return all DACs value

2. DAC <CHANNEL> : return current DAC value
  • <CHANNEL>: 0 - 7

3. DAC <CHANNEL> <VALUE> : set current DAC output to wanted voltage
  • <CHANNEL>: 0 - 7
  • <VALUE> - 0 - 3300 mV


The output is the same for all commands, in case you are using only the command DAC, you will get the following answer for each channel from 0 to 7:
RECV DAC <CHANNEL> <VALUE>


-- PeterZumbruch - 30 Mar 2015

-- PeterZumbruch - 2015-03-31

This topic: Epics > WebHome > EpicsProjectsAndActivities > HardwarePlatforms > HadCon2 > HadCon2MultipurposeControlsApi > HadConMultipurposeControlsProtocol > HadConMultipurposeControlsProtocolCmndDAC
Topic revision: revision 4
 
This site is powered by FoswikiCopyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding GSI Wiki? Send feedback
Imprint (in German)
Privacy Policy (in German)