MFU Software Release Notes

Refer to MFUSoftwareChangeLog for further version information.

007.00007
  • If an MFU LWL is used, DataStorage is not supported. I.e. ADC calibration (24 bit) and the functions of the [Data storage] tabs do not work. (29.03.23)
    Wird eine MFU LWL verwendet, wird DataStorage nicht unterstützt. D.h. ADC Kalibrierung (24 Bit) sowie die Funktionen der [Data storage] Tabs funktioneren nicht. (29.03.23)
    Workaround
    Use an MFU SE from FW 7.5.0
    This problem will be fixed in future versions of the Nios SW.
    Nutzen Sie eine MFU SE ab FW 7.5.0
    Dieses Problem wird in zukünftigen Versionen der Nios SW behoben.

007.00004
  • Due to a software error, the SCU exclusive interlock registers are not updated if there is NO interlock.
    This problem can occur sporadically and depends on when the interlock reset was carried out and whether menu 111 "Interlocks dynamical" is currently displayed.

    Workaround
    After deleting the interlocks, you have to switch once to menu 111 "Interlocks dynamical" if this was not displayed at the time of deletion. This updates the SCU exclusive interlock registers.
    This error will be fixed in future versions of the Nios SW.

All versions up to 007.00003
  • If the programmed interlock texts are read above the MFU FSP233, NO checksum will be sent at the end of the transmission. Only the ETX.
  • Werden Parameter mittels PCA an die MFU gesendet (egal ob ins RAM oder Flash), wird fälschlich jedes Mal ein Logbucheintag erstellt, der angibt, dass
    die Modulverifikation fehlgeschlagen ist. Das ist falsch und kann ignoriert werden. DasProblem ist in zuküftigen SW Versionen behoben.
  • Das int. Scope ist immer aktiv (unabhängig von den Parametern), weil am Ende der ‚scope_init()‘ Funktion der Trigger aktiviert wird.
    Das ist dahingehend fatal, als dass dadurch im Falle eines Triggerereignisses die 'status_pio_isr()' aufgerufen wird.
    Das selbst ist noch nicht das Problem, in der ISR aber, werden (durch das fehlerhaftes Bitmanagement) mitunter Bits "geserviced", die gar nicht als ISR-Quelle zugelassen sind.
    U.A. STATUS_CURRENTLY_RECEIVING_MFU_PARAMETERS_n, was dafür sorgte, dass CPU_STATUS_MODULES_VERIFIED gelöscht und WARNING_MODULE_VERFICATION_FAILED gesetzt wird.
    Workaround
    Da die Konfiguration des int. Scopes nicht Bestandteil der Parameter ist, ist z. Zt. kein "Umschiffen" möglich.

-- DerekSchupp - 2019-02-08

This topic: EPS > AdaptiveControlUnit > MFUSoftwareReleaseNotes
Topic revision: 2023-03-29, DerekSchupp
This site is powered by FoswikiCopyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding GSI Wiki? Send feedback | Legal notice | Privacy Policy (german)